Seta Oxi-Cor Bath - 15550-3
The Seta Oxi-Cor bath is a stainless steel water or oil bath. Temperature controlled by a top mounted thermostir circulator with integral over-temperature and low fluid level protection devices.
The bath has four test stations. Each has a lid with a hook, from which you suspend either a Corrosion Pressure Vessel (11500-0) or a test tube Support Assembly (11420-0), holding up to three Test Tubes (11590-0). You can use any combination of these.
NOTE: For oxidation tests, methods specify a certain bath volume per pressure vessel. In order to comply with this, you can only use two oxidation pressure vessels in the bath at the same time.
Seta Oxi-Cor Bath - 15550-3
You can replace one or more of the four lids with an Oxidation Vessel (15802-2). Pressure in the vessel can be monitored automatically with the Seta Auto-Oxi Control System (15452-2).
A Silver Corrosion Conversion Kit (11510-0) is available to convert test stations to hold Glassware - Silver Corrosion (11430-0).
Supplied with; 4 lids, mains lead and instruction manual.
|Temperature range||Ambient +5 °C to 150 °C|
|Temperature stability||±0.1 °C|
|Bath capacity||34 litres|
|Heater Power||1500 W|
|Voltage||110/120 V, 50/60 Hz 220/240 V, 50/60 Hz|
|Size (HxWxD)||520 × 485 × 330 mm|
|CCCN Code||Tariff 84198998|
|ASTM D4814||General Specification for Automotive Spark Ignition Engine Fuels|
|IP 227 (obs)||Corrosiveness to Silver of Aviation Turbine Fuels|
|BS EN ISO 2160 & BS 2000-154 & ISO 2160||Copper Corrosion from Petroleum Products by the Copper Strip Tarnish Test|
|ASTM D4048||Standard test method for detection of copper corrosion from lubricating grease|
|ASTM D873||Standard test method for oxidation stability of aviation fuels (potential residue method)|
|BS 2000-112 & IP 112||Determination of corrosiveness to copper of lubricating grease. Copper strip method|
|ASTM D5304||Oxidation Stability of Gasoline (Induction Period Method)|
|IP 154||Corrosiveness to Copper - Copper Strip Test|
|IP 40||Determination of oxidation stability of gasoline - Induction period method|
|ASTM D525||Standard test method for oxidation stability of gasoline (induction period method)|
|ASTM D130||Standard Test for Corrosiveness to Copper from Petroleum Products by Copper Strip Test|
|ASTM D7671||Corrosiveness to Silver by Automotive Spark–Ignition Engine Fuel–Silver Strip Method|
|IP 611||Corrosiveness to silver of automotive gasoline - Silver strip method|
|ASTM D7667||Corrosiveness to Silver by Automotive Spark-Ignition Engine Fuel—Thin Silver Strip Method|
|DIN EN ISO 2160||Petroleum products. Corrosiveness to copper. Copper strip test|
|BS EN ISO 7536 & BS 2000-40 & ISO 7536||Methods of test for petroleum and its products. Petroleum products. Determination of oxidation stability of gasoline. Induction period method|
|BS 2000-138 & IP 138||Methods of test for petroleum and its products. Determination of oxidation stability of aviation fuel. Potential residue method.|
|DIN EN ISO 7536||Determination of oxidation stability of gasoline by the induction period method|